How To Resurface A Badly Damaged Surface In Lakeside Ca?

7 Tips To Resurface A Badly Damaged Surface In Lakeside CaConcrete resurfacing is an effective way to repair a badly damaged surface. It is important to properly prepare the surface before applying any concrete resurfacing product. Here are seven tips for successfully resurfacing a badly damaged surface:

  1. Start by cleaning the entire area with a pressure washer or wire brush, removing all dirt and debris from the area. It is important to ensure no grease or oil is left behind, as this can affect the adhesion of the concrete resurfacing product.
  2. Protect any surrounding areas from overspray by covering them with plastic sheeting or tarps. This will help you avoid damaging anything that isn’t meant to be covered in resurfacing products.
  3. Once the area has been cleaned and prep work completed, it’s time to apply an etching solution designed to prepare the surface for a successful coating job. Let it sit on the surface for 10-15 minutes before rinsing it off with clean water.
  4. After rinsing, let the area dry completely then use sandpaper to smooth out any rough patches in the concrete. This will help create a smooth, even surface for the new resurfacing product to adhere to.
  5. Once the area is prepped, it’s time to apply the resurfacing product. It’s important to follow all manufacturer instructions when applying any concrete resurfacing product.
  6. When complete, let the area cure completely before using or walking on it once again. Depending on the product used and environmental conditions, this may take anywhere from 24 hours up to several days.
  7. Finally, seal the resurfaced area with a good-quality sealer designed for use on concrete surfaces. This will provide additional protection against weathering and wear-and-tear over time, helping to keep your newly resurfaced surface looking good for years to come.

FAQ’s

How Do You Refinish A Concrete Surface?

Concrete refinishing involves cleaning, etching and sealing the concrete surface to restore its natural luster. This can be done with a pressure washer or wire brush, followed by an etching solution and then sealed with a good-quality sealer designed for use on concrete surfaces.

How Long Does It Take To Refinish A Concrete Surface?

The time it takes to refinish a concrete surface depends on the size of the area being refinished as well as the type of resurfacing product used. Generally speaking, it should take approximately 2-3 hours to complete the job when following all manufacturer instructions.

Can You Resurface Existing Concrete?

Yes, you can resurface existing concrete. However, it is important to properly prepare the surface by cleaning and etching before applying any resurfacing product. This will help ensure a successful coating job and extend the life of your newly resurfaced surface.

Conclusion

It is important to properly prepare a concrete surface before applying any resurfacing product. Following the seven tips outlined in this article will help you successfully restore a badly damaged surface, saving you time and money in the long run. For more information, contact Concrete Contractor Lakeside Ca at (619) 678-0052.